Remoção de corantes têxteis utilizando adsorventes nanoporosos

Abstract

Synthetic dyes are one of the most common pollutants and often found in the textile industry. The disposal of wastewater containing dyes on water bodies is extremely important from an environmental standpoint, since the dyes even at low concentrations can be highly toxic to aquatic systems. The high stability and toxicity are the major problem in the treatment of wastewater containing dyes. This study examined three nanoporous adsorbents materials: a lamellar double hydroxide (LDH-Mg/Al), pillared clay (Al-PILC) and a commercial activated carbon (Norit GAC-1240), assessing hair performance in the removal of dyes Reactive Black 5 (RB5), Methylene Blue (MB) and Acid Blue 25 (AB25) used in the textile industry. The materials based on natural clays synthesized in the laboratory, and activated carbons were characterized by XRD, BET and FTIR, in order to obtain information about their structural and textural characteristics. Experiments using a batch stirred tank system were performed to investigate the effect of pH, the initial concentration of dye, contact time and ionic strength through adsorption of the dyes. For the system of stirred tanks a rotary shaker and acrylic tubes were used containing 20 mL of dye solutions in contact with 0.015 g of adsorbent. The equilibrium concentration of each dye was determined with a spectrophotometer UV/Vis. In order to describe the behavior of adsorption isotherms, the equilibrium data were correlated with the Langmuir model (L). The contribution of mass transfer parameters on the kinetics of adsorption of dyes RP5, AB25 and MB on activated carbon was also investigated. These data provide a basic understanding of mechanisms of mass transfer and dynamic diffusional system. The behavior of pH and ionic strength of the medium was very important for understanding of adsorption processes in the respective materials for each dye examined. The pH of the aqueous solutions was greatly different, which was dependent on characteristics anionic and cationic materials and colorants. According to statistical analysis, the Langmuir model was adequate to represent the data of adsorption of dyes shown. It may be noted that the kinetics of adsorption of dyes follow a similar behavior, with a sharp drop of the dye initial concentration in the supernatant in the first moments of contact, reaching the equilibrium in approximately 100 minutes. The adsorbed amounts of the three materials showed a revealed better performance obtained for activated carbon.